Gemel Txshs User Manual Direct

Press to deactivate the system. The indicators will flash once to confirm. Synchronization Procedure

Press both Button 1 and Button 2 simultaneously. Hold them for approximately 10 seconds until the LED on the remote stops flashing. Gemel Txshs User Manual

Turn the ignition OFF . Test the remote by arming and disarming the bike. Maintenance: Battery Replacement The Gemel TXSHS uses a CR 2032 3V lithium battery. Press to deactivate the system

If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor Hold them for approximately 10 seconds until the

Perform the described above to reconnect the remote to the bike. Troubleshooting

Provides visual feedback during operation and synchronization. Basic Operation Arming the Alarm

Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place.