Invt Che100-0r7g-s2 Manual Direct

Mounting: Always install the unit vertically to allow for natural heat dissipation.Clearance: Maintain at least 100mm of space above and below the unit, and 50mm on the sides.Temperature: Operate between -10°C and +40°C. If the ambient temperature exceeds 40°C, derate the output current by 3% for every additional degree.Moisture and Dust: Avoid direct sunlight, high humidity (above 95% RH), and corrosive gases. Wiring Diagram and Terminals

L, N: Connect your single-phase 220V AC power supply here.U, V, W: Connect these to your three-phase motor. (Note: Never connect input power to these terminals).(+) , (-): DC bus terminals for external braking units (if required).PE: Grounding terminal. Ensure a solid connection to prevent electromagnetic interference (EMI). Control Circuit Terminals invt che100-0r7g-s2 manual

The CHE100 utilizes a group-based parameter system. To enter programming mode, press the "PRG" key, use the arrows to find the group, and press "DATA/ENT" to modify. Essential Parameters for Startup Mounting: Always install the unit vertically to allow

High Voltage Warning: After powering off the drive, wait at least 5 minutes for the DC bus capacitors to discharge before touching any terminals.No Capacitors: Never connect capacitors or surge absorbers to the output (U, V, W) terminals.Phase Insulation: Before connecting the motor, use a megohmmeter to ensure the motor phase-to-ground insulation is intact. (Note: Never connect input power to these terminals)