Installation Manual - Ts1162

If the TS1162 is the last device on a long RS-485 cable run, set the termination DIP switch (typically Switch 8) to the 'ON' position to prevent data signal reflections. 4. System Integration

RS-485 data lines for communication with the Challenger panel. Request to Exit (RTE) input for controlling door egress. OUT (Open Collector) A 50mA output used to drive a door relay or door strike. ts1162 installation manual

Pull the bottom of the body away from the base and lift it off the top tabs. If the TS1162 is the last device on

Ensure the mounting surface allows the rear tamper lever to be fully depressed when the unit is secured. Enclosure Removal: Undo the retaining screws at the bottom of the keypad. Request to Exit (RTE) input for controlling door egress

Choose a flat, solid, vertical surface to prevent the base from warping when tightened.

The is a 3-LED Remote Arming Station (RAS) designed for use with Challenger security systems. Rated at IP67 , this robust keypad is suitable for both indoor and outdoor installations, including harsh, dusty, or wet environments.